分板机解决6毫米灯条不变形机器
Plate splitter solves the problem of 6 mm light bar without deformation
1.本机采用了独特的多，甚至更多的切割方法，通过切割八片完成板，二上下为一组，以形成切削单元。他们是A，B，C，D四组。整个切割过程分为四个阶段，一组叶片从A槽切断所述电路板的30％，然后再切刀片B还在叶片运行时，再次完成切割的30％的量，然后再次选自B刀片罐已碾过，切割刀片ç完成再次削减量的30％，最后由D组的最终切割刀片和擦拭器10％，由于少量的每次切割的，所以应力更传统的剪裁方式，以减少80％以上，在切割过程中产生，董事会较好的分割边缘光滑，董事会非常光滑，不扭曲不翘。目前仅切割铝塑板后去保证了机器的不变形。
This machine adopts a unique multi or even more cutting method, through cutting eight pieces of complete plate, two up and down into a group, in order to form a cutting unit. They are group A, B, C, D. The whole cutting process is divided into four stages: a group of blades cut 30% of the circuit board from slot a, and then the re cutting blade B completes 30% of the cutting amount again while the blade is still running, and then it is selected again from the B blade tank which has been rolled, the cutting blade (c) completes 30% of the reduction again, and finally, the final cutting blade and wiper of group D are 10% The stress is more traditional cutting method to reduce more than 80%, which is produced in the cutting process. The edge of the board is better, the edge is smooth, and the board is very smooth without distortion and warping. At present, only after cutting the aluminum-plastic plate to ensure that the machine does not deform.
2，由于多个切削起见，非常光滑切割过程，大大提高了V-CUT槽的靶向能力，即使V-CUT很浅的槽板，它不会从导向槽V-CUT刀出现跳出的，避免不良。
For the sake of multiple cutting, the cutting process is very smooth, which greatly improves the targeting ability of V-CUT groove. Even if the V-CUT is very shallow, it will not jump out from the V-CUT cutter of the guide groove, so as to avoid bad performance.
3.由于小刀片的切割力，并采用瑞典进口高速钢，切板铝板刀片寿命可达一年，当片的耐用性大大增强。
As a result of the high-speed steel blade imported from Sweden, the blade life can be greatly enhanced when cutting.
4，全部采用激光干涉的激光测量仪的校准，以确保刀后的第一刀可以继续通过槽精确切割所述切割刀片的。提示跳动不大于0.02mm。确保完美的切割质量。
After the first cutter is cut accurately, the laser cutter can continue to cut through all the cutting slots of the laser cutter. It is suggested that the run out is not more than 0.02mm. Ensure perfect cutting quality.
